inkstitch/symbols, branch nix

Improve satin guided ripple stitch and add stitch grid first option (#3436)

2025-01-26T06:37:21Z

* ripple stitch: add stitch grid first option * introduce an anchor line to fine tune satin guided ripples

Enable start end commands for satins (#3315)

2024-12-07T14:20:11Z

Updates commands fill_start (_end) => starting_point (_end) stain_start (_end) and run_start (_end) => autoroute_start ripple_target => target_point Sets inkstitch svg version to 3

Stitch plan preview overwrite option (#2642)

2024-01-14T19:42:36Z

scale markers as well (#1839)

2022-10-15T14:41:06Z

Add ripple stitch feature (#1667)

2022-05-24T17:40:30Z

Auto route for running stitch (#1638)

2022-05-18T14:02:07Z

* add auto route for running stitch * introduce free motion commands Co-authored-by: Lex Neva

markers and lettering (#1559)

2022-01-25T15:41:30Z

Revert "remove symbols SVG file" (#870)

2020-12-25T16:00:25Z

by @lexelby

remove symbols SVG file

2020-08-20T01:21:15Z

new extension: Auto-Route Satin Columns (#330)

2018-10-30T23:43:21Z

**video demo:** https://www.youtube.com/watch?v=tbghtqziB1g This branch adds a new extension, Auto-Route Satin Columns, implementing #214! This is a huge new feature that opens the door wide for exciting stuff like lettering (#142). To use it, select some satin columns and run the extension. After a few seconds, it will replace your satins with a new set with a logical stitching order. Under-pathing and jump-stitches will be added as necessary, and satins will be broken to facilitate jumps. The resulting satins will retain all of the parameters you had set on the original satins, including underlay, zig-zag spacing, etc. By default, it will choose the left-most extreme as the starting point and the right-most extreme as the ending point (even if these occur partway through a satin such as the left edge of a letter "o"). You can override this by attaching the new "Auto-route satin stitch starting/ending position" commands. There's also an option to add trims instead of jump stitches. Any jump stitch over 1mm is trimmed. I might make this configurable in the future but in my tests it seems to do a good job. Trim commands are added to the SVG, so it's easy enough to modify/delete as you see fit.