remove constants

1 files changed, 0 insertions, 52 deletions

diff --git a/lib/stitches/constants.py b/lib/stitches/constants.py
deleted file mode 100644
index 012fac7c..00000000
--- a/lib/stitches/constants.py
+++ /dev/null
@@ -1,52 +0,0 @@
-import math
-
-# Used in the simplify routine of shapely
-simplification_threshold = 0.01
-
-# If a line segment is shorter than this threshold it is handled as a single point
-line_lengh_seen_as_one_point = 0.05
-
-# E.g. to check whether a point is already present in a point list,
-# the point is allowed to be this value in distance apart
-point_spacing_to_be_considered_equal = 0.05
-
-# Adjacent geometry should have points closer than
-# offset*offset_factor_for_adjacent_geometry to be considered adjacent
-offset_factor_for_adjacent_geometry = 1.5
-
-# Transfer point distance is used for projecting points from already
-# rastered geometry to adjacent geometry
-# (max spacing transfer_point_distance_factor*offset)
-# to get a more regular pattern
-transfer_point_distance_factor = 1.5
-
-# Used to handle numerical inaccuracies during comparisons
-eps = 1e-3
-
-# When entering and leaving a child from a parent we introduce an offset of
-# abs_offset*factor_offset_starting_points
-# so that entering and leaving points are not lying above each other.
-factor_offset_starting_points = 0.5
-
-# if points are closer than abs_offset*factor_offset_remove_points one of it is removed
-factor_offset_remove_points = 0.5
-
-# decides whether the point belongs to a hard edge (must use this point during sampling)
-# or soft edge (do not necessarily need to use this point)
-limiting_angle = math.pi * 15 / 180.0
-
-# angles straighter (smaller) than this are considered as more or less straight
-# (no concrete edges required for path segments having only angles <= this value)
-limiting_angle_straight = math.pi * 0.5 / 180.0
-
-# if a point distance to the connected line of its two neighbors is smaller than
-# abs_offset times this factor, this point will be removed if the stitching distance will not be exceeded
-factor_offset_remove_dense_points = 0.2
-
-# if a soft edge is closer to a forbidden point than abs_offset*this factor it will be marked as forbidden.
-factor_offset_forbidden_point = 1.0
-
-# usually overnext projected points are preferred.
-# If an overnext projected point would create a much smaller segment than a direct
-# projected point we might prefer the direct projected point
-factor_segment_length_direct_preferred_over_overnext = 0.5